Andrei Popescu ha scritto:
> On Wed, Dec 13, 2006 at 08:08:57PM +1300, Simon wrote:
>
>> Hi There,
>>
>> Is there a way to set network cards to full duplex at boot time?
>>
>> Thanks Simon
>>
>
> Mine is set that way automatically. It would be helpful if you would
> specify which card and chipset, Debian release, kernel version, ...
>
> Regards,
> Andrei
>
Well, I have a switch that doesn' t work well with negotiation. So I
added these MII lines in /etc/init.d/networking (in the start section):
======================================================
start)
process_options
log_action_begin_msg "Configuring network interfaces"
if ifup -a; then
log_action_end_msg $?
else
log_action_end_msg $?
fi
/sbin/mii-tool -F 100BaseTx-HD eth0
/sbin/mii-tool -v eth0
;;
======================================================
These have to be done for every network card (HD stays for Half Duplex,
you need FD - Full Duplex - see the mii-tool manual).
For me this works.
Regards
Mirto
--
__________________________________________________________
Mirto Silvio Busico ICT Consultant
Tel. +39 333 4562651
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
