Sorry to hear that read-edid did not work for you. Perhaps PC2000 is not the manufacturer. I seem to remember a monitor certification called PC2000. (Googling....yes, here it is: <http://www.panasonic.com.au/products/faqs/details.cfm?detailsID=175&objectID=146&categoryID=0&productID=0&lListIDs=178,197,179,198,170,171,167,166,163,173,160,159,158,168,164,161,169,162,174,172,165,190,185,193,191,199,194,187,192,186,177,188,175,195,183,182,184,181,176,196,189,200,180>).
Other than that, I found: <http://www.si87.com/MonitorSolutions/kaga/fi769mt.html>, <http://www.si87.com/MonitorSolutions/pc2000/f1785t.html>, <http://www.forum.linux-sevenler.org/index.php/topic,866.0.html>, Which may be close enough. Also, if it is a 17" monitor (which I suspect it is), then you can't go wrong with the settings: Horz 35-60 Vert 55-90 These are VERY conservitive settings; you could probably go as high as 30-65,50-100 without worry. Good Luck, Kevin On Sun, 2005-08-21 at 19:10 +0200, Csanyi Pal wrote: > On Sun, Aug 21, 2005 at 06:24:34PM +0200, Alexander Schmehl wrote: > > * Csanyi Pal <[EMAIL PROTECTED]> [050821 17:18]: > > > I have the monitor PC2000 F17 69T. > > > It was given to me yesterday, but without the manual. > > > I need the technical informations bellow to set up my X Window: > > [..] > > > Has anybody these informations? If so, please tell me! Thanks! > > > > Take a look at read-edid [1], which might find that information for you. > > sudo get-edid > get-edid: get-edid version 1.4.1 > > Performing real mode VBE call > Interrupt 0x10 ax=0x4f00 bx=0x0 cx=0x0 > Function supported > Call successful > > VBE version 300 > VBE string at 0x11110 "Brookdale-G Graphics Chip Accelerated VGA BIOS" > > VBE/DDC service about to be called > Report DDC capabilities > > Performing real mode VBE call > Interrupt 0x10 ax=0x4f15 bx=0x0 cx=0x0 > Function supported > Call successful > > Monitor and video card combination does not support DDC1 transfers > Monitor and video card combination does not support DDC2 transfers > 0 seconds per 128 byte EDID block transfer > Screen is not blanked during DDC transfer > > Reading next EDID block > > VBE/DDC service about to be called > Read EDID > > Performing real mode VBE call > Interrupt 0x10 ax=0x4f15 bx=0x1 cx=0x0 > Function supported > Call failed > > The EDID data should not be trusted as the VBE call failed > Error: output block unchanged > > Thank you Alexander, but as You see abowe, I can't get the wanted > informations. > > -- > Regards, > Paul > Debian Junior Project, DebianEdu, Moodle -> :-) :-) :-) :-) :-) :-) :-) > http://www.ektf.hu/~Csanyi.Pal (Up to now, it is in Hungarian only.) > > -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
