I recently upgraded from woody to sarge per the
instructions (aptitude etc), which was successful.
However, after then upgrading the kernel from
2.2.20-idepci to 2.6.8-2-386, I found I could boot OK,
but I'd lost eth0 and the ATI framebuffer.
lspci can see both devices, but I'm at a loss as to
how to make the kernel see them again.
modprobe eth1349 seems to work OK. modprobe eth16i
fails, no hardware found. The card is a 3c905.
This must be a common question, but after a fair
amount of googling I haven't been able to spot an answer.
___________________________________________________________
To help you stay safe and secure online, we've developed the all new Yahoo!
Security Centre. http://uk.security.yahoo.com
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
