Everything below occurred after a fresh reboot. On Sat, Aug 13, 2005 at 11:23:35PM -0400, Antonio Rodriguez wrote: > I am going to add the following, which may be relevant: > > tail -f /var/log/messages > Aug 13 23:16:56 localhost gconfd (trc-4692): Resolved address > "xml:readonly:/etc/gconf/gconf.xml.defaults" to a read-only > configuration source at position 2 > Aug 13 23:17:00 localhost kernel: usb 2-1: control timeout on ep0in > Aug 13 23:17:03 localhost gconfd (trc-4692): Resolved address > "xml:readwrite:/home/trc/.gconf" to a writable configuration source at > position 0 > Aug 13 23:17:05 localhost kernel: usb 2-1: control timeout on ep0in > Aug 13 23:17:10 localhost kernel: usb 2-1: control timeout on ep0in > Aug 13 23:17:11 localhost kernel: parport0: PC-style at 0x378 (0x778) > [PCSPP,TRISTATE] > Aug 13 23:17:11 localhost kernel: parport0: irq 7 detected > Aug 13 23:17:11 localhost kernel: parport0: Printer, hp deskjet 5550 > Aug 13 23:17:11 localhost kernel: lp0: using parport0 (polling). > Aug 13 23:17:16 localhost kernel: usb 2-1: control timeout on ep0in > > Message from [EMAIL PROTECTED] at Sat Aug 13 23:17:46 2005 ... > localhost kernel: Disabling IRQ #193 > Aug 13 23:17:46 localhost last message repeated 6 times > Aug 13 23:17:46 localhost kernel: [__report_bad_irq+42/144] > __report_bad_irq+0x2a/0x90 > Aug 13 23:17:46 localhost kernel: [note_interrupt+112/176] > note_interrupt+0x70/0xb0 > Aug 13 23:17:46 localhost kernel: [do_IRQ+352/416] do_IRQ+0x160/0x1a0 > Aug 13 23:17:46 localhost kernel: [common_interrupt+24/32] > common_interrupt+0x18/0x20 > Aug 13 23:17:46 localhost kernel: [default_idle+0/64] > default_idle+0x0/0x40 > Aug 13 23:17:46 localhost kernel: [default_idle+44/64] > default_idle+0x2c/0x40 > Aug 13 23:17:46 localhost kernel: [cpu_idle+59/80] cpu_idle+0x3b/0x50 > Aug 13 23:17:46 localhost kernel: [printk+366/448] printk+0x16e/0x1c0 > Aug 13 23:17:51 localhost kernel: usb 2-1: control timeout on ep0in > Aug 13 23:18:16 localhost last message repeated 5 times > > Notice that the line > Message from [EMAIL PROTECTED] at Sat Aug 13 23:17:46 2005 ... > and all after it appeared after conecting the multicard. I disconected > the multicard without response. Hmm, sounds not good. > > > -- > To UNSUBSCRIBE, email to [EMAIL PROTECTED] > with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED] >
-- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
