On Wed, 2002-06-19 at 18:45, D.J. Bolderman wrote: > On Wed, 2002-06-19 at 17:21, Matthias Ellinger wrote: > > -----BEGIN PGP SIGNED MESSAGE----- > > Hash: SHA1 > > > > On Wednesday 19 June 2002 17:13, D.J. Bolderman wrote: > > > Does anybody have a clue how to fix this ? > > > > > > The board uses a VIA Apollo KT266A chipset. > > > > Try this: > > > > in lilo.conf, insert the line > > "append ide0=ata66", run lilo and reboot > > > > UDMA100 should work now, you can use hdparm to fine-tune the disks > > performance. > > Ok, did that, but my dmesg shows this: > > <snip> > > ide_setup: ide0=ata66 > > <snip> > > VP_IDE: chipset revision 6 > VP_IDE: not 100% native mode: will probe irqs later > VP_IDE: Unknown VIA SouthBridge, contact Vojtech Pavlik > <[EMAIL PROTECTED]> > VP_IDE: ATA-66/100 forced bit set (WARNING)!! > > > So it finds an unknown via southbridge... maybe this is the problem ? > Anyway, I still can't enable dma with hdparm...
Ok people, my problem is solved: I installed the prepatch 2.4.19-pre10 and now it get a much fast througput +/- 39mb/sec :) Regards Dick -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
