Moin guennelk!
[EMAIL PROTECTED] schrieb am Sunday, den 05. May 2002:
> PROMISE Fastrak100 IDE-PCI-card w/ 4x 60Gb IBM HDDs.
>
> I first installed the minimal-System on an extra HDD (hda), compiled a
> customised Kernel, set up the Raid and moved the System onto the Raid.
Why? Woody-Install with bf2.4-based boot-floppies does support ATARAID
out-of-the-box.
> So far, it works fine, even booting of the Raid (I have a
> RAID1-boot-partition and a RAID5-root-partition) using LILO works.
Uhm, with which driver? IIRC does the kernel driver support the RAID0
mode only.
> The only thing I do not get to work is booting without the extra HDD.
> If I use the MBR of the extra HDD (hda) for booting the System starts perfect,
> I even can change from this MBR (hda) to the MBR on the Raid-Disk (hde)
No. If you use RAID mode, you must install into MBR of the Raid disk,
/dev/ataraid/...
> I turned of the SCSI onboard in the Main-BIOS and define an Array in the
> RAID-BIOS, then my BIOS trys to boot of hde, if I set the Main-BIOS to
> SCSI boot, but LILO crashes after LI
So what now, hde or ataraid?
> Or does that not work at all without an extra HDD?
Well, I implemented and tested booting of ATARAID on a Highpoint Raid
controller (very similar), works fine with Woody now.
Gruss/Regards,
Eduard.
--
-!- Gromitt_ is now known as Gromitt
<@Getty> oh scheisse, gromitt wird wach
<@Getty> da hab ich jetzt soviele lines gemacht in den letzten 24 std.
<@Getty> und jetzt kommt der wieder ;)
-- #debian.de
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
