On Wed, 7 Feb 2001, mike polniak wrote: > > For most of the time 'xcdroast' command is > > answering: > > > > 'No Generic SCSI-Support has been detected.' > > (Anyway there are the modules sg and ide-sci emulation installed.) > > > > >From dmesg: > > ___________ > > > > hdc: Hewlett-Packard CD-Writer Plus 9100b, ATAPI CDROM drive > > hdd: CD-ROM 48X/AKU, ATAPI CDROM drive > > > > /etc/modules is as follows: > > > > eepro100 > > 3c59x > > 3c59x > > parport > > parport_pc > > parport_probe > > sg > > ide-scsi > > Make sure you also have module sr_mod (for scsi cdrom) and that scsi > support is set with CONGIG_SCSI.
Where is that module? If I'll run 'modconf' I cannot see that module. > Then to make sure the scsi modules are loaded in the right order and What is the right order? > see your CD-RW add the following in /etc/modutils/aliases > > options ide-cd ignore=hdc # tell the ide-cd module to ignore hdc > alias scd0 sr_mod # load sr_mod upon access of scd0 > pre-install sg modprobe ide-scsi # load ide-scsi before sg > pre-install sr_mod modprobe ide-scsi # load ide-scsi before sr_mod > pre-install ide-scsi modprobe ide-cd # load ide-cd before ide-scsi There is nothing like that on /etc/modutils/aliases Should I try writing it with hand? > > Then run update-modules that's all. Then remove sg and ide-scsi from > /etc/modules.Then as root run cdrecord -scanbus to see the CD-RW as a scsi > device. [EMAIL PROTECTED]
