> Didn't find any clue yet, what to do. > Still nothing happens. > For most of the time 'xcdroast' command is > answering: > > 'No Generic SCSI-Support has been detected.'
That's your problem ^^^ > (Anyway there are the modules sg and ide-sci emulation installed.) You're telling them to be loaded, but they aren't... > From dmesg: > ___________ > > hdc: Hewlett-Packard CD-Writer Plus 9100b, ATAPI CDROM drive > hdd: CD-ROM 48X/AKU, ATAPI CDROM drive > ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 > ide1 at 0x170-0x177,0x376 on irq 15 > hda: IBM-DTLA-307030, 29314MB w/1916kB Cache, CHS=3737/255/63 > hdc: ATAPI 32X CD-ROM CD-R/RW drive, 2048kB Cache > Uniform CD-ROM driver Revision: 3.11 > hdd: ATAPI 48X CD-ROM drive, 128kB Cache > Floppy drive(s): fd0 is 1.44M > FDC 0 is a post-1991 82077 > md driver 0.36.6 MAX_MD_DEV=4, MAX_REAL=8 > scsi: <fdomain> Detection failed (no card) > NCR53c406a: no available ports found > sym53c416.c: Version 1.0.0 > Failed initialization of WD-7000 SCSI card! > IBM MCA SCSI: No Microchannel-bus support present -> Aborting. > megaraid: v107 (December 22, 1999) > aec671x_detect: > 3w-xxxx: tw_findcards(): No cards found. > scsi : 0 hosts. > scsi : detected total. > Partition check: See, no SCSI emulation or SCSI cd-rom devices mentioned. Run "cdrecord -scanbus" and post it's output here. > /etc/modules is as follows: > <snip> > sg > ide-scsi I *think* you need to add an "append" line to your /etc/lilo.conf file. You need to tell the kernel that your /dev/hdc device is a "scsi" device now and let the scsi-emulation module control. This link, http://www.linuxdoc.org/HOWTO/CD-Writing-HOWTO-2.html#ss2.1, explains it more. I have scsi emulation compiled directly into my kernel so I don't need this setting. Regards Hall
