Peter Good <[EMAIL PROTECTED]> wrote: >Colin Watson wrote: >> G0DModE <[EMAIL PROTECTED]> wrote: >> >After unpacking the XFree 4.0 soft, I wanted to configure it, so I run >> >"XFree86 -configure" command and the output was: "Segmentation fault". I >> >tried to install over and over again, but always output was the same. >> >> Where did you get that command from? :) > >(snipped from the XFree86 4.0 Install file) >The next step is to configure the X server. That is covered in detail >in an as-yet unwritten document :-(. In the meantime, there are two >ways to create a basic X server configuration file for XFree86 4.0. >One is to run the xf86config utility. Another is to use the new >-configure X server option: > > XFree86 -configure >(End of snip) > >Thats where he would have got that command from.
Bah. In that case, somebody ought to update the man page in the documentation on the web. :( Sorry about that, -- Colin Watson [EMAIL PROTECTED]
