"Josh Kuperman" <[EMAIL PROTECTED]> wrote: I've had a similar configuration, but on @Home. I don't know about RoadRunner, but on [EMAIL PROTECTED], you must specify a hostname parameter to get an address from their DHCP servers. I seem to recall that pump didn't allow this but that dhcpcd did, and most folks here seem to go that route. Being lazy, I just used a fixed IP since it has only changed once in 3 years (new cable modem installed).
There are a number of cable modem setup pages that give much more specific info on RoadRunner than I can. I'd recommend a search of those. At this point, you've got all the hard parts working (presumably). > Then I need to set up > Squid on the machine, while the machine runs a tiny very secure little > private network for a few machines off of the eth2 interface that goes > out through the cable modem on eth1, while providing access to a local > web server on eth0. So you want pump to get an address off of a DHCP server on eth2 (the LAN)? Or am I mis-reading something here? Good luck! - Bob
