I have 3 AT1500-BT NICs using the lance module, I want them to get set up as follows. I had wanted to complete the install from my RoadRunner Connection but I couldn't get the DHCP Client to work so I used a fixed IP connection on my private network - currently running on RedHat and handling masquerading - for the initial install and upgrade.
eth0 - static ip, lance, irq=5 io=0x300 eth1 - trying to use pump, lance, irq=3 io=0x320 eth2 - static ip, lance, irq=4 io=0x360 Basically, I'm lost. I had to configure initially with a fixed IP address in order to do the install because from reading the archives in looked like pump was my best bet to get roadrunner working. This also updated me from /etc/init.d/network to /etc/init.d/networking - but it is still using /etc/init.d/network with all the entries commented out. Nor do I have the slightest idea what goes in the modules file - I'm working from memory and I can't even remember where I found the modules file now. I did review the info from the Networking and Ethernet How-Tos but I had to move up to Frozen in order to get pump which means the networking is being done differently. I need to know what entries to put /etc/init.d/networking, how and where to tell it to use pump for eth1 as well as were the parameters go for the three ethernet cards. I took some guesses but so far all I can do is bring up the single card on my private network. -- Josh Kuperman [EMAIL PROTECTED]
