I believe the Netgear rt328 is an OEM product from Zyxel <http://www.zyxel.com>. I've used Combinet (now Cisco) and Ascend. The Zyxel box is by far the easiest to configure. It's especially good for connecting to multiple sites and masquerading as different IP addresses on different connections. Check out the P100 for low end stuff or P128 if you need management (SNMP) or IPX.
My only warning on the zyxel routers is test the pots ports when you get the unit. Make sure the volume is ok and there is no buzzing. I had several zyxel products with pots problems, but the data services have been solid. On Mon, Oct 26, 1998 at 06:20:54AM -0700, Gregory Green wrote: > I have had great luck with the Netgear RT328. It is cheap ($280) and it is a > fully > functional router. This one has one ethernet interface and the next model up > has a > four port hub built in. No messing around with kernel tweaking, or > installing an > internal card, you just configure it over your LAN via telnet or serial port. > It has > all the dial on demand and multilink ppp options, and two analog ports like > the other > more expensive ones. > I shopped around a bit before I decided to go with this one and I am very > happy with > it. > > Steven Udell wrote: > > > Hello, > > > > I need advice on what ISDN adapter to get. > > > > I have looked at the: > > 3comImpact IQ (serial) "modem" external device.. > > But am concerned about the limit of 115K speed on the serial port. > > And people say its just a toy..not a solid ISDN choice..(250.00 cost too) > > > > I have also looked at the: > > Cisco 766 or 776 ISDN router external. (quite expensive) > > One has just one eth port and the other has an intergrated 4 port 10baseT > > hub. > > On this one how well it would work with Linux. Connected to my Eth card > > in my Linux box, would it use diald ? .. Would I compile the linux kernel > > with ISDN support for this? > > > > Or should I go with a lower cost(most likely) ISDN adapter card.. > > I don't know which way I should go.. I will need it networked & > > I need a analog phone port for a fax & voice phone. I wouldn't mind > > useing the Linux kernels ISDN function either.. ;) But what should > > I look at..in terms of Adapter cards..suggestions? > > > > Steve Udell > > [EMAIL PROTECTED] > > 10 more days till the ISDN wireing is in .... > > > > -- > > Unsubscribe? mail -s unsubscribe [EMAIL PROTECTED] < /dev/null > > -- > Gregory Green > AdvantageCom, Inc. > http://www.advantagecom.com > > > > -- > Unsubscribe? mail -s unsubscribe [EMAIL PROTECTED] < /dev/null -- Lee Bradshaw [EMAIL PROTECTED] (preferred) Alantro Communications [EMAIL PROTECTED]
