Hi again,
Thanks to Ralph for his instructions (below). However, after packaging
the kernel, then installing I still get the following message when I run
lsof:
mort:~# lsof
lsof: kernel symbol address mismatch: el3_probe
get_kernel_syms() value is 0x2825004; /boot/System.map-2.0.33 value
is 0x1a444c.
There was 1 additional mismatch.
/boot/System.map-2.0.33 and the booted kernel may not be a matched
set.
Any ideas what is causing this?
My lilo config is the following:
boot=/dev/hda2
root=/dev/hda2
compact
install=/boot/boot.b
map=/boot/map
vga=normal
delay=0
image=/vmlinuz
label=Linux
read-only
/vmlinuz is a symlink to /vmlinuz-2.0.33. This kernel and the file
/boot/System.map were installed by the kernel package.
Thanks for any help,
Chris
On Sat, 6 Jun 1998, Ralph Winslow wrote:
> When Chris wrote, I replied:
>
> This is what I last did:
>
> I already had loaded the make-kpkg package, if you havn't, get it
> using dselect.
>
> Use dselect to download the kernel I wanted. (Since this was the same
> as my previous, bo, version, I did "cd /usr/src/kernel; rf -rf *"
> first).
>
> cd /usr/src/kernel; make config # you may prefer xconfig
>
> make-kpkg --bzimage kernel-image
>
> cd ..; dpkg --install <the_package_I_just_made>.deb
>
> It was just that simple for me, YMMV - if it does, post to this list and
> I'm sure the help you need will be forth coming. The make config (or
> xconfig, if you prefer) step is more complicated than it looks as you
> must
> answer detailed questions about your hardware and desired software
> options
> and these answers aren't always obvious. Write down the question, guess
> an answer, and when you're done, don't go on to the next step until you
> seek advice (this list is a terrific place to get that) and, if
> necessary,
> re-run make config if you find that there are better answers than those
> you first gave.
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
