Craig Russell wrote:
Roberto C. Sanchez wrote:
On Thu, Jun 09, 2005 at 05:54:21PM -0400, Craig Russell wrote:
Trying to compile the 2.6.8 kernel from the debian source package
(patched) and I keep on running into this problem after reboot. I
have gone back and checked to make sure that the ide drivers have been
compiled in but after 5 or 6 attempts I am still getting this error.
The kernel appears to compile fine. I am using Lilo to as my boot
manager and I created an initrd.img with mkinitrd -o
/boot/initrd.img.2.6.8 2.6.8. I created the kernel package via
fakeroot make-kpkg --revision=custom.1.0 kernel_image and this
installs fine (or so it appears).
I've been searching the web and tried many of the suggestions but I'm
still getting the same error.
The end result of this operation is to run free/swan with the native
ipsec support in the 2.6 kernel.
Thanks for any help you can offer.
OK. Two things:
1. Use GRUB. It is better. It is easier to configure. It doesn't
require a reinstall for every new kernel.
2. Don't make an initrd unless you have a really good reason (e.g., you
want / on LVM or LVM+RAID, or you also need the kernel to fit on a
floppy and you can't get the core small enough).
Now, on to sloving the problem. What filesystem is your / partition?
What filesystems are you buidling with the kernel? If they are modules,
are you sure that they are in the initrd? What are the contents of your
initrd and what is your kernel config?
-Roberto
ok-
taking these suggestions (and I concur, grub is a lot easier) I still
have the same problem with the kernel panic. / is on /dev/hda1 swap
on /dev/hda2; grub recognizes the new kernel and it is an option on
the menu. I went back and re-verifed that ext2 and ext3 filesystems
are configured into the kernel and *NOT* as modules. I did a make
clean and a make-dpkg clean and recompiled and re-installed the new
kernel. No compilation errors, no installation errors, but still the
same can't mount root fs error.
One thing I'm confused on is the ide drivers in the 2.6 kernel. While
reading the help under ATA, etc. it states that I should be using the
scsi driver for ide drives unless I have legacy equipment (which I
don't, Vision computers x86 based, new in the last 2 weeks), but under
the scsi drivers section it asks for a specific driver and does not
list anything remotely close to what i've got.
So, I'm at a logjam.
Thanks for the help
Craig Russell
Airdigitalnetwork.com
Ok-
Found a couple of threads, one from this list, couple from other sites
via google and I've tried the following:
disabled Advanced Partitioning (suggested on one list)
made sure ide support was compiled into the kernel
switched boot manager to grub (somewhat unrelated, but one reply
suggested I should move to it and it is easier to use)
I've tried with and without initrd without luck
made sure that the correct filesystem support is compiled into the kernel
tried all kinds of different options in the kernel config
Still having the same problem.
Any suggestions are welcome. I am continuing to experiment but since it
takes 30 minutes + for each compilation if I'm missing something stupid
I'd really appreciate the help. I've done this on 2.4 kernels several
times (with issues, but managed to figure them out via google archives,
etc.) so I'm guessing that I'm missing something that is specific to the
2.6 kernel.
Thanks,
Craig Russell
AirDigitalNetwork.com
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
