-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Hello,
I'm sprry this message maybe partly off topic but I don't find any better location to post questions at. Now my problem: I am finally running debian sarge on a 43p Model 150 RS6000 Machine ( CHRP ). This machine has a IBM(?) Fire GL1 card built in which by default uses a resolution of 1600x1200 Pixels. I'm running this machine at a 15 inch TFT because of lack of space, so I'm not able to display anything with the machine ( until I use my father's 21 inch monitor which I'm currently using for test purposes ). Unfortunately I'm able to change the resolution. The only place where I can change the resolution is AIX ( smit ) and this only changes the X-Server's resolution to 1024x768 which runs fine until finally the X-Server is up. Of course I cannot display anything else then. To make it short, I didn't find a way to change the resolution of OF Screen, OK Prompt, Debian Linux Console or SMS Menu in that locations: ~ - setenvs ( ok prompt ) ~ - firmware variables ( also ok prompt ) ~ - SMS Menu ~ - AIX ~ - Linux ( uses framebuffer by default, won't use any driver ) ~ - X-Server on Openfirmware framebuffer ~ - Graphics Card Firmware ( I didn't find utilities or updates to change hard-coded resolution ) ~ - I searched User's Guide, Setup Instructions, Service Guide, RS6000 Graphics Handbook ( only partly ) for ~ - Jumpers, Firmware updates, tools, utility floppies Is it possible to change display resolution or will I propably to reprogram any EEPROM? And when which? Where can I find appropriate images to burn on the graphics card? Or may I even buy another card? Thanks for every answer in advance Greetings Philipp Vollmer -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.2.6 (FreeBSD) Comment: Using GnuPG with Thunderbird - http://enigmail.mozdev.org iD8DBQFCTsRr9KYBCQQof6YRApYNAKCH/e8ZN1jwBcvcRoz+G3pMVbESnQCgvq0x 8rQWGjeqbtkdvEnRmevh9T0= =97PT -----END PGP SIGNATURE-----
