Hi I downloaded the special pegasos 1 netinst iso at :
http://people.debian.org/~luther/pegasos/sarge-pegasos1-netinst-2004.10.25.iso In the OF-prompt I typed boot /pci/ide/[EMAIL PROTECTED],0 PEGASOS1.;1 as my CD-Rom-drive is the primary master. Then I get after about 20 seconds lines like: >chrpboot starting >initial ramdisk >gunzipping >heap consumed >start adddress >calling quiesce >return 0x0 from prom_init afterwards I get stucked and even after 120 seconds there is no Linux boot prompt. I have a ATI radeon 9200 AGP card which is identified by lspci as follows: 0000:01:00.1 Display controller: ATI Technologies Inc RV280 [Radeon 9200 SE] (Secondary) (rev 01) My wh0000:00:00.0 Host bridge: Mai Logic Incorporated Articia S Host Bridge (rev 01) 0000:00:01.0 PCI bridge: Mai Logic Incorporated Articia S PCI Bridge 0000:00:06.0 FireWire (IEEE 1394): VIA Technologies, Inc. IEEE 1394 Host Controller (rev 46) 0000:00:07.0 ISA bridge: VIA Technologies, Inc. VT8231 [PCI-to-ISA Bridge] (rev 10) 0000:00:07.1 IDE interface: VIA Technologies, Inc. VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06) 0000:00:07.2 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 1e) 0000:00:07.3 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 1e) 0000:00:07.4 Non-VGA unclassified device: VIA Technologies, Inc. VT8235 ACPI (rev 10) 0000:00:07.5 Multimedia audio controller: VIA Technologies, Inc. VT82C686 AC97 Audio Controller (rev 40) 0000:00:07.6 Communication controller: VIA Technologies, Inc. Intel 537 [AC97 Modem] (rev 20) 0000:00:08.0 Ethernet controller: VIA Technologies, Inc. VT6102 [Rhine-II] (rev 51) 0000:00:0b.0 Unknown mass storage controller: Silicon Image, Inc. (formerly CMD Technology Inc) PCI0680 Ultra ATA-133Host Controller (rev 02) 0000:00:0c.0 Ethernet controller: VIA Technologies, Inc. VT6105 [Rhine-III] (rev 86) 0000:01:00.0 VGA compatible controller: ATI Technologies Inc RV280 [Radeon 9200 SE] (rev 01) 0000:01:00.1 Display controller: ATI Technologies Inc RV280 [Radeon 9200 SE] (Secondary) (rev 01) pole lspci returns: I never managed to compile a bootable kernel from the official debian kernel-source-2.6.8 even when I took a .config from a working kernel made from the gentoo 2.6.8-pegasos-r2 sources. And I had always the same problem, that the kernel just never continued after the prom_init. Any hints? -- Niklaus Giger Wieshoschet 6 CH-8753 Mollis
