On Monday 09 June 2003 15:57, [EMAIL PROTECTED] wrote: ... > went fine. However on my Power Mac, I am getting crashes during the > configuration of some newly installed packages. I have gotten the > following errors during the dozen or so times I have tried the > configuration after install. ... > <#2, kernel panic> > unable to handle kernel paging request at virtual address 15015805 > (error 42000000) <followed by usual traceback information> ... > and a CD-R on SCSI bus 0. I have been running MacOs 9.1 on this > machine for some time without difficulty. Otherwise I would swear I > have a hardware problem. ... > system go fine, as long as I do not allow the installer to do a bad > block check on the drive. I have gone through this several times, and > any time I allow the installer to check for bad blocks, it crashes the > machine. ... > kept getting worse until I experienced another crash. ... > usually the same. First off, am I doing something wrong? Second is it > possible I have a hardware problem that is not affecting MacOs, but is > making Linux unhappy? I do not know this model, is this an SMP machine? It looks like hardware failure to me.
Mark -- Krisztian Mark Szentes produktivIT - Open-Source Solution Provider Siebenbrunnengasse 55/7 A-1050 Wien
