Em Qua 01 Jun 2005 09:15, Martin Habets escreveu: > On Tue, May 31, 2005 at 09:12:47PM -0300, Gunther Furtado wrote: > > Hello, > > > > This is the reading I get whe I boot the 2.4.25-behn kernel. > > > > Parition check: > > hda: [mac] hda1 hda2 hda3 hda4 hda5 hda6 hda7 hda8 hda9 hda10 hda11 hda12 > > > > And this is when i boot a kernel I compiled from linux-2.4.26 sources. > > > > Partition check: > > /dev/ide/host0/bus0/target0/lun0: [mac] p1 p2 p3 p4 p5 p6 p7 p8 p9 p10 > > p11 p12 > > > > Can anyone tell what did I switched off from Behn's kernel configuration? > > The benh kernel accesses the hard disk as an IDE device. Your later kernel > sees it as a SCSI device. First check if you have a boot parameter like > "hda=scsi" and if so, remove it. >
There were not "hda=scsi" in may yaboot.conf file. But, if my kernel accesses the HD as SCSI, why the line after partition check: /dev/ide/host0/bus0/target0/lun0: [mac] p1 p2 p3 p4 p5 p6 p7 p8 p9 p10 p11 p12 reads /dev/ide and not /dev/scsi ? Gunther Furtado ------------------ Curitiba - PR - Brasil -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
