On 14 Apr 2004, [EMAIL PROTECTED] wrote: > Uwe > > What messages do you get when you plug in the floppy? Use dmesg to > look at these if you are not sure where to find them. > > I have a TEAC USB floppy which is not yet supported.. I'm about to > sell it to get one of the Mitsumi drives. > > Dave Cox > Hi Dave,
Thanks for you fast reply, I get something like ttyS0: LSR safety check engaged! usb.c: USB disconnect on device 00:02.0-1 address 3 sr0: CDROM not ready. Make sure there is a disc in the drive. sr0: CDROM not ready. Make sure there is a disc in the drive. sr0: CDROM not ready. Make sure there is a disc in the drive. sr0: CDROM not ready. Make sure there is a disc in the drive. sr0: CDROM not ready. Make sure there is a disc in the drive. ttyS0: LSR safety check engaged! sr0: CDROM not ready. Make sure there is a disc in the drive. sr0: CDROM not ready. Make sure there is a disc in the drive. hub.c: new USB device 00:02.0-1, assigned address 4 WARNING: USB Mass Storage data integrity not assured USB Mass Storage device found at 4 sr0: CDROM not ready. Make sure there is a disc in the drive. sr0: CDROM not ready. Make sure there is a disc in the drive. sr0: CDROM not ready. Make sure there is a disc in the drive. ttyS0: LSR safety check engaged! sr0: CDROM not ready. Make sure there is a disc in the drive. sr0: CDROM not ready. Make sure there is a disc in the drive. sr0: CDROM not ready. Make sure there is a disc in the drive. sr0: CDROM not ready. Make sure there is a disc in the drive.
