-----BEGIN PGP SIGNED MESSAGE----- Thanx for the suggestion. Unfortunately, I had already tried changing this value in /ect/pcmcia/config and still get errors. It loads the module fine, but when it tries to start the network, after "executing './network start tulip_cb' it says it can't find module tulip_cb, same thing for ./serial start tulip_cb, then it complains that it can't find /dev/tulip_cb or make it. The config file points to xircom_tulip_cb not tulip_cb, so why does it keep looking for the tulip_cb module?
Mark Demma http://www.demma.net "Apathy is tyranny's greatest ally." On Thu, 2 Nov 2000, Paul Schulz wrote: > Greetings, > > Here is the patch that I submitted that fixes this problem for the > 2.4.0 kernel. Once patched it will break 2.0.x... (the choise is yours) > > PaulS > > --- config.dpkg Mon Oct 30 22:37:44 2000 > +++ config Mon Oct 30 22:39:11 2000 > @@ -106,6 +106,10 @@ > > device "airo_cs" > class "network" module "airo", "airo_cs" > + > +device "xircom_tulip_cb" > + class "network" module "cb_enabler", "xircom_tulip_cb" > + > # > # Ethernet adapter definitions > # > @@ -1724,7 +1728,7 @@ > > card "Xircom CBEM56G-100 CardBus 10/100 Ethernet + 56K Modem" > version "Xircom", "*", "CBEM56G" > - bind "tulip_cb" to 0, "serial_cb" to 1 > + bind "xircom_tulip_cb" to 0, "serial_cb" to 1 > > card "Xircom RBM56G Modem" > manfid 0x0105, 0x1000 > > -----BEGIN PGP SIGNATURE----- Version: 2.6.3ia Charset: noconv iQCVAwUBOgGyIasy97xeIU49AQHfCwP/cM9lTzWg92QSqzEzPwg6TaA7u3aSoVor xuidy7UrzmtXKXR4yWUkEk34+cAhdV4zZ3DDEFmgyTirHJ+yv+ULhYEu47M91mSc /PWDVzpqa9q1Ir69MdK7bnoy3PrxnXh7gPVRT5NeU2Jc9gb6ACzP/cGoBpGduHLj 0oWvlyNa9nM= =CMeK -----END PGP SIGNATURE-----
