Andrey wrote:
> $ sudo ip link set wlan0 up
> $ sudo iw dev wlan0 scan
> BSS XX:XX:XX:XX:00:03 (on wlan0)
[...]
> Information elements from Probe Response frame:
> SSID: repeat
> Supported rates: 1.0* 2.0* 5.5* 11.0* 18.0 24.0 36.0 54.0
> DS Parameter set: channel 10
> ERP: Barker_Preamble_Mode
> Extended supported rates: 6.0 9.0 12.0 48.0
> BSS XX:XX:XX:XX:18:ed (on wlan0)
> ----- output cuted off -----
>
> $ sudo iw dev wlan0 connect -w repeat
> wlan0 (phy #0): failed to connect, status: 1: Unspecified failure
Thanks. Could we have the corresponding "dmesg" output snippet, too?
(ideally with notes on how the timing corresponds to the commands run)
Your original report included a log with
[ 4309.262135] iwlagn 0000:03:00.0: RF_KILL bit toggled to enable radio.
[...]
[ 6069.680858] iwlagn 0000:03:00.0: RF_KILL bit toggled to disable
radio.
Is that when you switched the hardware rfkill switch? Is the rfkill
switch set to "enabled" or "disabled" now?
Please also try version 3.2-rc7 from experimental. Full "dmesg"
output from booting up and reproducing the problem would be useful.
If it also reproduces the problem (and I don't see any reason for it
not to) we can take this upstream.
Hope that helps,
Jonathan
--
To UNSUBSCRIBE, email to debian-kernel-requ...@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org
Archive: http://lists.debian.org/20120116204159.GC12699@burratino
