2011/9/18 ael <law_ence....@ntlworld.com>: > I have just done another run: > > $ gpsbabel -w -i garmin -f /dev/ttyUSB0 -o gpx -F test.gpx > [ERROR] GPS_Packet_Read: Timeout. No data received. > GARMIN:Can't init /dev/ttyUSB0 > > The dmesg output for this test was as before: > ---------------------------------------------------------------- > [ 3219.397130] > /build/buildd-linux-2.6_3.0.0-3-i386-G7H4XL/linux-2.6-3.0.0/debian/build/source_i386_none/drivers/usb/serial/ark3116.c: > ark3116_set_termios - setting bps to 9600 > [ 3219.397144] > /build/buildd-linux-2.6_3.0.0-3-i386-G7H4XL/linux-2.6-3.0.0/debian/build/source_i386_none/drivers/usb/serial/ark3116.c: > ark3116_set_termios - setting hcr:0x00,lcr:0x13,quot:313 > [ 3219.398612] usb 2-1: ark3116: don't know how to do software flow control > [ 3219.405693] > /build/buildd-linux-2.6_3.0.0-3-i386-G7H4XL/linux-2.6-3.0.0/debian/build/source_i386_none/drivers/usb/serial/ark3116.c: > ark3116_set_termios - setting bps to 9600 > [ 3219.405718] > /build/buildd-linux-2.6_3.0.0-3-i386-G7H4XL/linux-2.6-3.0.0/debian/build/source_i386_none/drivers/usb/serial/ark3116.c: > ark3116_set_termios - setting hcr:0x00,lcr:0x13,quot:313 > [ 3223.865457] > /build/buildd-linux-2.6_3.0.0-3-i386-G7H4XL/linux-2.6-3.0.0/debian/build/source_i386_none/drivers/usb/serial/ark3116.c: > ark3116_read_int_callback - urb shutting down with status: -2 > ---------------------------------------------------------------------------- > > Otherwise, on the module load (before the test), just: > > [ 3152.500579] USB Serial support registered for ark3116 > [ 3152.501577] usbcore: registered new interface driver ark3116 > [ 3152.501588] ark3116:v0.6:USB ARK3116 serial/IrDA driver > [ 3155.956189] usb 2-1: new full speed USB device number 3 using uhci_hcd > [ 3156.115248] usb 2-1: New USB device found, idVendor=6547, idProduct=0232 > [ 3156.115269] usb 2-1: New USB device strings: Mfr=1, Product=3, > SerialNumber=0 > [ 3156.115283] usb 2-1: Product: USB-UART Controller > [ 3156.115294] usb 2-1: Manufacturer: ArkMicroChips > [ 3156.119333] ark3116 2-1:1.0: ark3116 converter detected > [ 3156.130227] usb 2-1: ark3116 using RS232 mode > [ 3156.130611] usb 2-1: ark3116 converter now attached to ttyUSB0 > > Hope something here gives a clue... > Alas, no. As far as I can tell, the hardware is correctly setup to do 9600N8 without rtscts handshaking. Nothing in the log about a failing transmit, so it seems that gpsbabel's command goes out to the device, but somehow nothing is received in response. I'll try to see if my 3116 still works with a 3.0 kernel, hopefully tomorrow. Maybe that brings us further.
Groeten, Bart -- Bart Hartgers - New e-mail: bart.hartg...@gmail.com -- To UNSUBSCRIBE, email to debian-kernel-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org Archive: http://lists.debian.org/CAK7h4ycdr0M75QYFHVFgePbHYyoJdx4Z=7mjyespxkstgu9...@mail.gmail.com
