On Mon, Apr 22, 2002 at 02:56:12PM +0200, [EMAIL PROTECTED] wrote: > Yep, I did so, but I'm running into problems. > Everything looks good for about 10 min. then I > loose connectivity to the loopback of my Linux box, > but the route stay's in the Cisco's route table. > After pinging from Cisco to each ethX interface of the > Linux box, the loopback is back reachable. > > my setup is like this: > > two switches connected to a Cisco 7513. > a Linux box connected to each switch. > The Linux box has an additional lo:1 interface.
What is the lo:1 interface for? Have you tried using a dummy network device instead? (e.g. dummy0) I'm not sure I can help with the OSPF config, since I've not used OSPF before. -- Michael Wood <[EMAIL PROTECTED]> -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
