-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
> -----Original Message-----
> From: Florian Friesdorf [mailto:[EMAIL PROTECTED]]On Behalf Of
> Florian Friesdorf
> Sent: Sonntag, 17. Juni 2001 16:40
> To: [EMAIL PROTECTED]
> Subject: Re: Remote Resue Disk
>
>
> On Sat, Jun 16, 2001 at 05:02:55PM +0800, Jason Lim wrote:
> > Hi all,
> >
> > I was about to develop my own "Remove Rescue Disk)... but thought
> > maybe you had a better idea or had already done this...
> >
> > Regularly if the hard disk fails or needs a manual fsck (usually
> > just pressing y throughout), then it means a trip to the
> > datacenter
> at whatever
> > ungodly hour it may be for this relatively simple task.
> >
> > If it was possible to create a boot disk with a simple telnetd
> > (and minimum network support) and static e2fsck utilities, then,
> > in
> theory, all
> > that needs to be done is to insert the disk, reboot the server,
> > and the telnetd binds to a special, pre-defined IP just for this
> > emergency purpose. Then I can telnet in from home or wherever,
> > run
> e2fsck, mount the
> > drives, see /var/log/syslog, etc. to see what went wrong. After
> > the repairs, the disk can be removed, and server rebooted.
> >
> > Does this sound realistic? Even if 2 disks or even 3 were
> required, if it
> > means I can save a trip to the datacenter it would be worthwhile
> > to do.
> >
> > Perhaps you guys have thought of something similar, or maybe
> there already
> > IS something like this out there? Any ideas/suggestions would be
> > greatly appreciated.
>
> Another approach would be, (however you need at least 2 computers)
> to connect the computers serial ports with null-modem cables and
> tell lilo and the kernel to use the serial port as console.
>
> You then logon on the one computer to get the console of the other.
>
> Kind of a cheap console server.
>
> I have not tried it, but I think it should work.
> Could someone comment on this?
>
>
> florian
>
Hi Flo!
I'm using this solution for my ISDN-Router. This is a small linux-box
with no vga-card. You have to add the line "console=ttyS0" to your
lilo config, and then you can use a terminal program (minicom, etc.)
to control the box. If you add a serial getty in your /etc/inittab,
you have a console too. (this is very usefull, if your nic isn't
working:) )
Michael Schwarzbach
+--------------------------------------------------+
| /"\ |
| \ / |
| X ASCII RIBBON CAMPAIGN - AGAINST HTML MAIL |
| / \ |
`~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~'
-----BEGIN PGP SIGNATURE-----
Version: PGPfreeware 7.0.3 for non-commercial use <http://www.pgp.com>
iQA/AwUBOyzifgUqVktPGYHYEQLElACgldup8i5bFF5GmiyNyoRbN5esL8QAoN70
pH6RkeqoKIbBtc+fKKYNjF/p
=HsyH
-----END PGP SIGNATURE-----
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
