On Tue, Apr 18, 2006 at 09:26:49PM +0200, Frans Pop wrote:
>
> Right, made a bit of a mess with that.
> Better do:
> # echo options libata atapi_enabled=1 >> /etc/modprobe.d/libata
> and delete whatever file that was created because of my earlier completely
> broken suggestion.
I have finally gotten the sata CD/DVD drive to work on my Etch system.
I never managed to get it working with the original installed kernel,
so decided to try a change to the kernel configuration..
However after installing the kernel source and doing a test compile with
no changes at all to the configuration, I found that the CD/DVD worked
with the new kernel.
The commands I used to rebuild the kernel were:
apt-get install kernel-package
apt-get instal linux-tree-2.6.15
cd ~digbyt/kernel;tar xfj /usr/src/linux-source-2.6.15.tar.bz2
cd linux-source-2.6.15; cp /boot/config-2.6.15-1-686 .config
make-kpkg --rootcmd fakeroot --initrd --append-to-version -drst \
--revision 1 kernel-image
dpkg -i ../linux-image-2.6.15-drst_1_i386.deb
and now I get:
.
.
ata1: SATA max UDMA/133 cmd 0x14B8 ctl 0x140E bmdma 0x14A0 irq 201
ata2: SATA max UDMA/133 cmd 0x14B0 ctl 0x140A bmdma 0x14A8 irq 201
usb 4-2: new full speed USB device using uhci_hcd and address 2
hda: max request size: 1024KiB
ata1: dev 0 cfg 49:0f00 82:0000 83:0000 84:0000 85:0000 86:0000 87:0000 88:0407
ata1: dev 0 ATAPI, max UDMA/33
ata1(0): applying bridge limits
hda: 117210240 sectors (60011 MB), CHS=16383/255/63, UDMA(100)
hda: cache flushes supported
hda: hda1 hda4 < hda5<4>ata1: PIO error
ata1: dev 1 cfg 49:0000 82:0000 83:0000 84:0000 85:0000 86:0000 87:0000 88:0000
ata1: no dma
ata1: dev 1 not supported, ignoring
ata1: dev 0 configured for UDMA/33
scsi0 : ata_piix
hda6 hda7 hda8 hda9 hda10 hda11 hda12 hda13 hda14 hda15 >
ATA: abnormal status 0x7F on port 0x14B7
ata2: disabling port
scsi1 : ata_piix
Vendor: MATSHITA Model: DVD-RAM UJ-832S Rev: 1.01
Type: CD-ROM ANSI SCSI revision: 05
Attempting manual resume
Not sure what the PIO error during the partition display for hda
means. Hda seems to be working fine after the boot.
Regards,
DigbyT
--
Digby R. S. Tarvin digbyt(at)digbyt.com
http://www.digbyt.com
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
