Package: installation-reports INSTALL REPORT
Debian-installer-version: Sarge i386 beta 2, downloaded last week uname -a: Linux squid 2.4.22-1-386 #9 Sat Oct 4 14:30:39 EST 2003 i686 GNU/Linux Date: 21 Feb 2004 13:12:27 Method: Installed off CD and then used local apt-proxy which in turn grabbed binaries off ISP mirror and mirror.aarnet.edu.au when required Machine: Clone yum cha Processor: Pentium III 600MHz powerbeast Memory: 256M Root Device: IDE, /dev/hda Root Size/partition table: hda1 1G ext3 / hda2 1G swap swap hda5 6G ext3 /usr hda6 6G ext3 /var hda7 6G ext3 /home Output of lspci: 00:00.0 Host bridge: VIA Technologies, Inc. VT82C693A/694x [Apollo PRO133x] (rev 44) 00:01.0 PCI bridge: VIA Technologies, Inc. VT82C598/694x [Apollo MVP3/Pro133x AGP] 00:07.0 ISA bridge: VIA Technologies, Inc. VT82C596 ISA [Mobile South] (rev 23) 00:07.1 IDE interface: VIA Technologies, Inc. VT82C586A/B/VT82C686/A/B/VT8233/A/C/VT8235 PIPC Bus Master IDE (rev 10) 00:07.2 USB Controller: VIA Technologies, Inc. USB (rev 11) 00:07.3 Host bridge: VIA Technologies, Inc. VT82C596 Power Management (rev 30) 00:08.0 Ethernet controller: Lite-On Communications Inc LNE100TX (rev 20) 01:00.0 VGA compatible controller: NVidia / SGS Thomson (Joint Venture) Riva128 (rev 21) Base System Installation Checklist: Initial boot worked: [O] Configure network HW: [O] Config network: [O] Detect CD: [O] Load installer modules: [O] Detect hard drives: [O] Partition hard drives: [O] Create file systems: [O] Mount partitions: [O] Install base system: [O] Install boot loader: [O] Reboot: [O] [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it Comments/Problems: Well done dudes, much better than old ones. Now I know this file exists I'll send you the sparc details too. Something that throws me every time. Partition the drives then you do the setup of the partitions (ext2/ext3/swap/leave). It picks up the old partition type which is usually WinNT. A wishlist, why does it ask me if I want ext2/ext3 on a partition of type swap? It should only be choosing swap/leave alone. Problem with apt sources config, I use manual setup and it gets the package files right but then loops back to Edit/Cancel step for configuring apt. I just Cancel then manually go to next step (which is select packages). Strangess too... I install new version of exim4 but then it asks me to configure mail server in installer. It's clever enough to know I have already done it so it goes to next step. Install logs and other status info is available in /var/log/debian-installer/. Once you have filled out this report, mail it to [EMAIL PROTECTED] -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
