Hi, 8 вересня 2012 о 17:16 +0100 Martin Michlmayr написав(-ла): > The testing installer boots fine on my TS-219. Can you try again on > your TS-212?
I tried to use testing d-i again, and it went better. First I set up a DHCP server and TFTP server on my laptop and disconnected the modem that also has built-in DHCP server from the network. With this configuration QNAP obtained an IP address, downloaded d-i image, rebooted into d-i, obtained the IP address again, and did nothing for several minutes, till I rebooted it. After reboot - the same problem, I can ping QNAP, but it does not start the ssh server. So I stopped the laptop's DHCP server and connected my modem to network. After I rebooted QNAP ssh worked fine, and it took around a minute to boot. Can it be that D-I requires full network configuration, with gateway, DNS, and so on via DHCP? That the only difference I can think about. After I connected to QNAP via ssh and downloaded installer components, I was presented with a list of languages to choose from. The list was quite small (screenshot: http://people.debian.org/~eugen/di-languages.png ). For example, Ukrainian was not in the list. There were no non-latin languages in the list. Some languages using Latin scripts were missing too. Why? I tested the installer only till I was able to mount the hard drive and reflash the kernel from the working system. There were no other problems. Regards, Eugeniy Meshcheryakov
signature.asc
Description: Digital signature
