I apologize for not making my problem clear. I have an stl file describing a complex model, I extracted some points of this complex model and drew a coarse mesh with gmsh, then ran step-54, but the mesh refinement does not follow the surface of the stl file. The refinement is only inside the coarse mesh. On Tuesday, October 29, 2024 at 10:56:15 AM UTC+8 Wolfgang Bangerth wrote:
> On 10/28/24 20:53, 王艺康 wrote: > > > > I set up a coarse mesh and then use step-54, to refine the coarse mesh > for > > projection onto a complex stl model, I'd like to enquire about the > feasibility > > of doing this! > > You say that you set up the mesh and use step-54. What happens when you > run > the code? In other words, I'm not quite sure what your concrete question > is :-) > > Best > Wolfgang > > -- > ------------------------------------------------------------------------ > Wolfgang Bangerth email: bang...@colostate.edu > www: http://www.math.colostate.edu/~bangerth/ > > > -- The deal.II project is located at http://www.dealii.org/ For mailing list/forum options, see https://groups.google.com/d/forum/dealii?hl=en --- You received this message because you are subscribed to the Google Groups "deal.II User Group" group. To unsubscribe from this group and stop receiving emails from it, send an email to dealii+unsubscr...@googlegroups.com. To view this discussion visit https://groups.google.com/d/msgid/dealii/0e0d50e3-2b66-4ed9-87a4-0bd316dbcc44n%40googlegroups.com.
