On 10/28/24 20:53, 王艺康 wrote:
I set up a coarse mesh and then use step-54, to refine the coarse mesh for
projection onto a complex stl model, I'd like to enquire about the feasibility
of doing this!
You say that you set up the mesh and use step-54. What happens when you run
the code? In other words, I'm not quite sure what your concrete question is :-)
Best
Wolfgang
--
------------------------------------------------------------------------
Wolfgang Bangerth email: bange...@colostate.edu
www: http://www.math.colostate.edu/~bangerth/
--
The deal.II project is located at http://www.dealii.org/
For mailing list/forum options, see
https://groups.google.com/d/forum/dealii?hl=en
---
You received this message because you are subscribed to the Google Groups "deal.II User Group" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to dealii+unsubscr...@googlegroups.com.
To view this discussion visit
https://groups.google.com/d/msgid/dealii/029ac3ea-bf2d-457f-a1e0-0daa3f2236dd%40colostate.edu.
