On 9/22/20 10:41 AM, Paras Kumar wrote:
As can be seen in figures 7 & 8 of the attached report, a further refinement
results in relatively smoother contours, but the irregularities are still not
eliminated.
OK, that's good to know at least as a check that your program is doing
something right.
This approach would probably not be applicable for our use-case since, we
need to model the interface between the filler and the matrix regions accurately.
Then I'm afraid I'm out of ideas short of using a program that can actually
create hex meshes :-(
Best
W.
--
------------------------------------------------------------------------
Wolfgang Bangerth email: bange...@colostate.edu
www: http://www.math.colostate.edu/~bangerth/
--
The deal.II project is located at http://www.dealii.org/
For mailing list/forum options, see
https://groups.google.com/d/forum/dealii?hl=en
---
You received this message because you are subscribed to the Google Groups "deal.II User Group" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to dealii+unsubscr...@googlegroups.com.
To view this discussion on the web visit
https://groups.google.com/d/msgid/dealii/459e62ee-8a36-63b3-bc42-54a47877f054%40colostate.edu.
