On 4/3/2010 5:55 PM, Robrecht Dewaele wrote: >> I'm using cygwin 1.7.2 on Windows 7, and I am unable to set the icrnl flag >> for >> /dev/ttyS2 as shown at the bottom of my message. The device attached >> to ttyS2 is a ARM development board which uses an ftdi chip for serial >> communication over USB. >> (The device is connected with USB, and the driver creates a virtual com >> port.)
> Are you running them as Administrator? (UAC or no UAC, this matters.) > -- > ~ > Morgan Gangwere Yes, the user account I'm running this on is an administrator account. Running cygwin as administrator (with right-click, run as ...) does not change the behavior. I must add that I am able to successfully change the baud rate, but not able to change most of the other flags. Changing icrnl does not render an error, but still nothing changed (see below). (this is on a Windows 7 VM, other HW is the same) ro...@eagle764 ~ $ stty -F /dev/ttyS2 onlcr ro...@eagle764 ~ $ stty -F /dev/ttyS2 speed 9600 baud; line = 0; intr = <undef>; quit = <undef>; erase = <undef>; kill = <undef>; eof = <undef>; swtch = <undef>; susp = <undef>; rprnt = <undef>; werase = <undef>; lnext = <undef>; flush = <undef>; min = 0; time = 0; -cread -brkint -icrnl -imaxbel -opost -onlcr -isig -icanon -iexten -echo -echoe -echok -echoctl -echoke -- Problem reports: http://cygwin.com/problems.html FAQ: http://cygwin.com/faq/ Documentation: http://cygwin.com/docs.html Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple
