it pretty easy on my 30 close valve on gas tank disconnect hose at the carb and start boat yoga if you have a 160 pcs wrench it will do pretty much everything on the boat some will say to install the smallest main jet prevent from washing your oil,economy and power it a great engine to work on and bullet proof
On Fri, May 30, 2025 at 3:58 PM Nicholas Floersch via CnC-List < cnc-list@cnc-list.com> wrote: > Hey folks! > > Is there any good online guide to removing the carburetor from an Atomic 4 > - especially in a CNC? > > We have a CNC 34 (’78) and I have the sense I need to remove and clean the > carburetor. > > I see where it is according to the manual … and with my eyes … but it > seems like a real challenge to reach in and pull it off with so little room > to maneuver… or even see the screws easily. > > I’m pretty new to engine maintenance. I’m not afraid to try … but I’d also > like to note break things. I’ve got a friend who is a car mechanic that has > an ultrasonic bath and can clean a carburetor just fine. So in my mind the > main trick is removing and re-installing it properly. > > Thanks for any insight! > > Nick Floersch in Vermont. > Your contributions help pay the fees associated with this list and help to > keep it active. Please help by making a small contribution using PayPal > at: https://www.paypal.com/paypalme/stumurray All contributions are > greatly appreciated. -- Joel Delamirande *www.jdroofing.ca <http://www.jdroofing.ca>*
Your contributions help pay the fees associated with this list and help to keep it active. Please help by making a small contribution using PayPal at: https://www.paypal.com/paypalme/stumurray All contributions are greatly appreciated.
