Andrew Rod rigging is much more expensive than wire. On a C&C115 a number of years ago the turnbuckles were replaced on the shrouds on both sides using the existing rod. The cost was over 3K
Someone once told me that the cost of a single rod was about the same as the cost of all the wire standing rigging on a boat. Then someone else told me that it was the cost of all the fittings on each end of the shrouds and stays that were the big cost. Bottom line is lets not lose our rig! MIke From: andrew macLean via CnC-List <cnc-list@cnc-list.com> Sent: October 1, 2021 4:13 PM To: Stus-List <cnc-list@cnc-list.com> Cc: andrew macLean <andre...@icloud.com> Subject: Stus-List Re: Mast in and out Doug, That sounds like a lot! What does $18k buy you? Surely more than a mast step and new shrouds? Our surveyor advised that our standing rigging was near the end of its service life. $18k is more than I have to spend. Andrew MacLean C&C 30mk1 Gulf Islands, BC On Oct 1, 2021, at 12:02 pm, Doug via CnC-List <cnc-list@cnc-list.com<mailto:cnc-list@cnc-list.com>> wrote: Jim, I went to port Townsend rigging, was quoted $13k for all new standing rigging. Ended up with an $18k bill. $3k just for the crane to pull and restep the mast. Doug Mountjoy sv Rebecca Leah C & C Landfall 39 Port Orchard Yacht Club Port Orchard, WA -------- Original message -------- From: Jim Watts via CnC-List <cnc-list@cnc-list.com<mailto:cnc-list@cnc-list.com>> Date: 10/1/21 10:52 (GMT-08:00) To: 1 CnC List <cnc-list@cnc-list.com<mailto:cnc-list@cnc-list.com>> Cc: Jim Watts <paradigmat...@gmail.com<mailto:paradigmat...@gmail.com>> Subject: Stus-List Mast in and out As part of a quote for potentially painting the topsides, we were given a cost for the local rigger to take the mast out and put it back in. I thought $1500 was a little steep, but I haven't done this since we had our 29-2, so maybe prices have gone up by 10X in the interim. I'm curious as to what kind of costs folks are incurring on their mast work just to see if this is reasonable. I also recently got a quote for $4500 which then ballooned to $9000 and counting to replace our rod rigging with wire. Does this sound at all in the ballpark? Jim Watts Paradigm Shift C&C 35 Mk III Victoria, BC Thanks to all of the subscribers that contributed to the list to help with the costs involved. If you want to show your support to the list - use PayPal to send contribution -- https://www.paypal.me/stumurray Thanks - Stu
Thanks to all of the subscribers that contributed to the list to help with the costs involved. If you want to show your support to the list - use PayPal to send contribution -- https://www.paypal.me/stumurray Thanks - Stu