You think Map gas will be good enough? On Mon, Jun 1, 2020, 11:17 Doug Mountjoy via CnC-List <cnc-list@cnc-list.com> wrote:
> Josh, > I used to work in a machine shop where I had to remove gears off of > shafts. We used an acetylene torch to heat the gear fast, so the shaft > didn't expand as fast. Using a slow heat source will heat the coupling and > shaft at about the same rate. You want to expand the coupling faster than > the shaft expands. > > > > Doug Mountjoy > sv Rebecca Leah > C&C Landfall 39 > Port Orchard yacht club > _______________________________________________ > > Thanks everyone for supporting this list with your contributions. Each > and every one is greatly appreciated. If you want to support the list - > use PayPal to send contribution -- https://www.paypal.me/stumurray > >
_______________________________________________ Thanks everyone for supporting this list with your contributions. Each and every one is greatly appreciated. If you want to support the list - use PayPal to send contribution -- https://www.paypal.me/stumurray
