Rob,
Boy is this familiar. I am in the same boat (so to speak). The lazarette doesn't maintain the same size throughout its length, it gets narrower the farther aft you go. I bought a 6 gallon from West Marine in the fal and am in the process of installation now. The wood trim piece (attached be screws from underneath has to be remove and a little spreading force may ben needed to make it fit (1/4 of an inch (6-7 mm) or so ). The west Marin heater measures 13.5 inches square and the opening is "just" short of 13.5 inches at the most aft portion. I'm going to give it a try this week and will let you know if I can make it happen. Neil Andersen S/V FoxFire 1982 C&C 32 Rock Hall, MD 21661 -----Original Message----- From: CnC-List <cnc-list-boun...@cnc-list.com> On Behalf Of Robert Abbott via CnC-List Sent: Tuesday, May 26, 2020 9:36 AM To: cnc-list@cnc-list.com Cc: Robert Abbott <robertabb...@eastlink.ca> Subject: Stus-List Hot Water Heater My hot water heater needs replacing....the existing one is round, 14 inches in diameter.....it should just, I mean just, come out of the locker without dismantling it so the new one can be no bigger. Can anyone with experience with hot water heaters recommend a replacement, specific model number? Rob Abbott AZURA C&C 32 - #277 Halifax, N.S. _______________________________________________ Thanks everyone for supporting this list with your contributions. Each and every one is greatly appreciated. If you want to support the list - use PayPal to send contribution -- <https://www.paypal.me/stumurray> https://www.paypal.me/stumurray
_______________________________________________ Thanks everyone for supporting this list with your contributions. Each and every one is greatly appreciated. If you want to support the list - use PayPal to send contribution -- https://www.paypal.me/stumurray
