When mine acted like that it was the circuit board. If you go the pro route make sure they are knowledgeable with 12 volt systems. I went the pro route (residential) and he overcharged the system. It took me a while to get the pressure lowered. If you have a danfoss compressor there is lots of info of the web.
Mike 37 k/cb Persuasion > On Sep 29, 2019, at 6:11 PM, Robert Gallagher via CnC-List > <cnc-list@cnc-list.com> wrote: > > I have what appears to be an original circa 1999 Cold Machine. The > compressor runs and cycles off for very short periods. Sometimes the > temperature is perfect at 34-38 for days on end, then then other times it > will stay in the high 40's - low 50's. Shutting it off and letting it sit > for a few hours seems to help but this could be anecdotal. > > Two questions before I call in a pro. > > Has anyone have advice for self repair? > Is it worth calling in a pro with a unit this old, or should I just remove > and replace? > > Thanks in advance, > > Rob > _______________________________________________ > > Thanks everyone for supporting this list with your contributions. Each and > every one is greatly appreciated. If you want to support the list - use > PayPal to send contribution -- https://www.paypal.me/stumurray >
_______________________________________________ Thanks everyone for supporting this list with your contributions. Each and every one is greatly appreciated. If you want to support the list - use PayPal to send contribution -- https://www.paypal.me/stumurray
