Thank you all, worked out well and ready to go! Cheers Envoyé de mon iPhone
> Le 1 juill. 2019 à 07:23, Michael Brannon via CnC-List > <cnc-list@cnc-list.com> a écrit : > > Maurice, the stem ball fittings rotate as they are tightened. They are > basically threaded to a spacer piece which goes through the mast and allows > them to move. I’m making the assumption that you still have the original > rod and fittings. > > Mike > > > Mikel Brannon > Virginia Lee 93295 > C&C 36 CB > Virginia Beach, VA > > > >> On Jun 28, 2019, at 5:11 PM, Maurice Poulin via CnC-List >> <cnc-list@cnc-list.com> wrote: >> >> Hello all, >> >> I raised tha mast today and rigged the shrouds except for the lowers on both >> side. These two shrouds have a curve where they enter into the mast. I am >> not sure if they are well positionned so did not want to tighten the >> turnbuckles and kink the rod at those curves. Would anyone know how the rod >> is held inside the mast and if I need to ensure the shrouds are straight and >> aligned to the chain plate. I hope I am describing accurately. >> >> Thank you for your valuable input >> >> cheers, >> >> Maurice Poulin >> Monoloy C&C 30 mkii >> _______________________________________________ >> >> Thanks everyone for supporting this list with your contributions. Each and >> every one is greatly appreciated. If you want to support the list - use >> PayPal to send contribution -- https://www.paypal.me/stumurray >> > > _______________________________________________ > > Thanks everyone for supporting this list with your contributions. Each and > every one is greatly appreciated. If you want to support the list - use > PayPal to send contribution -- https://www.paypal.me/stumurray >
_______________________________________________ Thanks everyone for supporting this list with your contributions. Each and every one is greatly appreciated. If you want to support the list - use PayPal to send contribution -- https://www.paypal.me/stumurray
