Maurice, the stem ball fittings rotate as they are tightened. They are basically threaded to a spacer piece which goes through the mast and allows them to move. I’m making the assumption that you still have the original rod and fittings.
Mike Mikel Brannon Virginia Lee 93295 C&C 36 CB Virginia Beach, VA > On Jun 28, 2019, at 5:11 PM, Maurice Poulin via CnC-List > <cnc-list@cnc-list.com> wrote: > > Hello all, > > I raised tha mast today and rigged the shrouds except for the lowers on both > side. These two shrouds have a curve where they enter into the mast. I am > not sure if they are well positionned so did not want to tighten the > turnbuckles and kink the rod at those curves. Would anyone know how the rod > is held inside the mast and if I need to ensure the shrouds are straight and > aligned to the chain plate. I hope I am describing accurately. > > Thank you for your valuable input > > cheers, > > Maurice Poulin > Monoloy C&C 30 mkii > _______________________________________________ > > Thanks everyone for supporting this list with your contributions. Each and > every one is greatly appreciated. If you want to support the list - use > PayPal to send contribution -- https://www.paypal.me/stumurray >
_______________________________________________ Thanks everyone for supporting this list with your contributions. Each and every one is greatly appreciated. If you want to support the list - use PayPal to send contribution -- https://www.paypal.me/stumurray
