I would not suggest a wooden fuel tank and I suspect the insurance company would not either!!!!!!!!!!!!!
Joe From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Sylvain Laplante via CnC-List Sent: Tuesday, September 04, 2018 12:44 PM To: cnc-list@cnc-list.com Cc: Sylvain Laplante <sylvain_lapla...@yahoo.ca> Subject: [EXTERNAL] Re: Stus-List C&C 30' mk1 replacement fuel tank I don't know if the 30 is like the 27, but when the thanks was leaking I made one of Plywood-epoxy and used all the fittings from the previous tank ( Proto Tank ), The tough part is to make it fit the unequal sides, I made a model from cardboard first. That was in 1998 and it is still ok. Sylvain C&C27 MkIII On Tuesday, September 4, 2018, 9:13:37 AM EDT, Gary Nylander via CnC-List <cnc-list@cnc-list.com<mailto:cnc-list@cnc-list.com>> wrote: I have replaced my tank. A problem in the original one, being made of aluminum and sitting on a piece of plywood, is that it (over 36 years) will develop pin holes and leak. Then you get to pump diesel out of your bilge. A second problem is the original has a elbow welded in the top which allows the input hose to exit sideways on the starboard side. I could not find a tank which would fit on the shelf which did not have a vertical input – and thus not allow the (very not flexible) input hose to turn down in time. I went to a smaller Moeller tank (11 gallons) instead of the original 19. Others have drilled a fill hole in the cockpit floor and put the filler in straight. The Moeller tank I have was about $175 or so as opposed to some others which didn’t appear to fit any better for $400 or more. You can get a bunch of other tanks by Googling Moeller and/or chasing down some other manufacturers. Or…. Take your tank out and find an aluminum welder and have a new bottom welded on (may be the best overall solution). The rest of the tank was fine, just the bottom was perforated. Gary Nylander 30-1 #593 From: CnC-List <cnc-list-boun...@cnc-list.com<mailto:cnc-list-boun...@cnc-list.com>> On Behalf Of Steve Guiney via CnC-List Sent: Tuesday, September 4, 2018 8:44 AM To: cnc-list@cnc-list.com<mailto:cnc-list@cnc-list.com> Cc: Steve Guiney <stevengui...@gmail.com<mailto:stevengui...@gmail.com>> Subject: Stus-List C&C 30' mk1 replacement fuel tank Hello I'm wondering if anyone replaced their original fuel tank and know the dimensions of have a Moeller part number? _______________________________________________ Thanks everyone for supporting this list with your contributions. Each and every one is greatly appreciated. If you want to support the list - use PayPal to send contribution -- https://www.paypal.me/stumurray
_______________________________________________ Thanks everyone for supporting this list with your contributions. Each and every one is greatly appreciated. If you want to support the list - use PayPal to send contribution -- https://www.paypal.me/stumurray
