Try taking it’s mate to a bearing supply and see if they can match it. Sent from my iPhone
On Jul 4, 2018, at 4:42 PM, Glenn Gambel via CnC-List <cnc-list@cnc-list.com<mailto:cnc-list@cnc-list.com>> wrote: I decided to clean my Barient 28 two speed self tailing winches today. It was sunny and nice and I had been putting the project off for a while. I did not think I would run into many problems, and that was a mistake. I did, but won't go into those now. Suffice to say, I did get the winch apart and was cleaning the parts and organizing them for reassembly, and discovered that one of the bearing had separated. Though I recovered all of the parts and have them, I think reassembly may be very difficult, and even if I could reassemble the thing, I suspect that it may not hold together once the winch is operated, especially under load. Does any one know where I might order new bearing or find new bearings for my Barient 28 two speed self tailing winch? Any idea or help would be appreciated. I would get the part number, but have to figure that out. Sincerely, Glenn Gambel Wind N Spirits C&C 36 _______________________________________________ Thanks everyone for supporting this list with your contributions. Each and every one is greatly appreciated. If you want to support the list - use PayPal to send contribution -- https://www.paypal.me/stumurray
_______________________________________________ Thanks everyone for supporting this list with your contributions. Each and every one is greatly appreciated. If you want to support the list - use PayPal to send contribution -- https://www.paypal.me/stumurray
