Arco winches in Australia. Joel
On Wed, Jul 4, 2018 at 4:42 PM Glenn Gambel via CnC-List < cnc-list@cnc-list.com> wrote: > > I decided to clean my Barient 28 two speed self tailing winches today. It > was sunny and nice and I had been putting the project off for a while. I > did not think I would run into many problems, and that was a mistake. I > did, but won't go into those now. Suffice to say, I did get the winch > apart and was cleaning the parts and organizing them for reassembly, and > discovered that one of the bearing had separated. Though I recovered all > of the parts and have them, I think reassembly may be very difficult, and > even if I could reassemble the thing, I suspect that it may not hold > together once the winch is operated, especially under load. > > Does any one know where I might order new bearing or find new bearings for > my Barient 28 two speed self tailing winch? Any idea or help would be > appreciated. I would get the part number, but have to figure that out. > > Sincerely, > Glenn Gambel > Wind N Spirits > C&C 36 > _______________________________________________ > > Thanks everyone for supporting this list with your contributions. Each > and every one is greatly appreciated. If you want to support the list - > use PayPal to send contribution -- https://www.paypal.me/stumurray > > -- Joel 301 541 8551
_______________________________________________ Thanks everyone for supporting this list with your contributions. Each and every one is greatly appreciated. If you want to support the list - use PayPal to send contribution -- https://www.paypal.me/stumurray
