John, I don't think so...my old tank had vent verticle..i got a 90* elbow for inlet...i have about 17" and tank is 12" plus the connections. Bill Walker CnC 36
Sent from AOL Mobile Mail On Thursday, September 14, 2017 John and Maryann Read via CnC-List <cnc-list@cnc-list.com> wrote: Hi Bill I am also planning to replace our tank. The Moeller tank looks like the vent and outlet vertically oriented fittings which makes fitting under the cockpit sole a tight affair. Can the tank be ordered with these fittings on a 90 degree el fitting?? John and Maryann Legacy III 1982 C&C 34 Noank, CT From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of William Walker via CnC-List Sent: Thursday, September 14, 2017 12:43 PM To: cnc-list@cnc-list.com Cc: wwadjo...@aol.com Subject: Stus-List Fuel Tank Replacement Moving ahead on the project. Old tank out. New ordered and delivered by Amazon in 2 days..Moeller 19 gallon, 16 x 12 x 26. 90 degree hose and straight hose connector as I think Dennis mentioned. Two questions: First, if I leave at least 2 inches of the 1.5 inch fuel line inlet connector, can I trim its height if I need to? It is going to be really tight to get the 90 degree elbow on. need to keep the plastic "sawdust" out of tank somehow. Second, the old aluminum tank was bonded to the deck filler and the to the engine block. Since this is plastic tank should I skip tank and bond deck filler directly to engine? What about the sending unit. Thanks Bill Walker CnC 36 Pentwater, Michigan Sent from AOL Mobile Mail _______________________________________________ This list is supported by the generous donations of our members. If you wish to make a contribution to offset our costs, please go to: https://www.paypal.me/stumurray All Contributions are greatly appreciated!
_______________________________________________ This list is supported by the generous donations of our members. If you wish to make a contribution to offset our costs, please go to: https://www.paypal.me/stumurray All Contributions are greatly appreciated!
