You can coil rod Rigging to no less than 200 times it's diameter.

Dennis C.

On Nov 3, 2016 9:21 AM, "Patrick Davin via CnC-List" <cnc-list@cnc-list.com>
wrote:

> I'm considering doing a rerig this winter. There are no obvious problems,
> but it's getting on 33 years now and would be nice for the peace of mind.
> Does anyone know of any blogs / websites / emails that do sort of a step by
> step guide to do-it-yourself rerigging?
>
> I'd like to do it myself to save on labor costs, but work with a local
> rigger hopefully to help with ordering the parts. I have one in mind who
> did my rig inspection plus replaced the D2s last year.
>
> The D2s (diagonals from lower spreader to mast near upper spreaders) are
> already new rod as of last year, due to some small cracks found at the
> upper rod ends of the old rod.
>
> I have the original rig schematics diagram. However Navtec no longer makes
> some of these parts. I understand the spreader 3-way join and the mast
> tangs are the tricky part.
>
> I searched the list archives but didn't find much on rerigs. I know Wally
> did a rerig but he didn't cover the details of it. I've seen some riggers
> say rerig requires unstepping the mast, but I'm not sure why they say this.
> If I can do this without pulling the mast that will save a lot of work and
> expense.
>
> Releasing the side shrouds at the upper terminations (stemballs) requires
> lifting the rod to near parallel to the ground and then unscrewing the
> navtang. When we did the D2s, this was easy. The caps unscrewed without any
> special efforts like heating. The uppers could be more difficult because
> they're longer (and perhaps hard to lift parallel to earth).
>
> If anyone knows of a good guide (ideally specific to C&C's) to this, I'd
> love to read it.
>
> -Patrick
> 1984 C&C LF38
> Seattle, WA
>
>
>
> _______________________________________________
>
> This list is supported by the generous donations of our members. If you
> wish to make a contribution to offset our costs, please go to:
> https://www.paypal.me/stumurray
>
> All Contributions are greatly appreciated!
>
>
_______________________________________________

This list is supported by the generous donations of our members. If you wish to 
make a contribution to offset our costs, please go to:  
https://www.paypal.me/stumurray

All Contributions are greatly appreciated!

Reply via email to