I just did mine and it was also a bit off at the ends. So I got a true strut ID once I pressed the bearing out.
Petar Horvatic Sundowner 76 C&C 38MkII On the hard at Stanleys in barrington From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Joel Aronson via CnC-List Sent: Thursday, February 11, 2016 6:45 PM To: cnc-list@cnc-list.com Cc: Joel Aronson Subject: Re: Stus-List Cutlass bearing size issue Brian, Mine was hard to measure because there was a slight taper to the hole at the ends of the strut. You might double check the measurement. 1 5/8 would be odd. Joel On Thursday, February 11, 2016, Brian Fry via CnC-List <cnc-list@cnc-list.com> wrote: Attempting to replace cutlass bearing. Shaft is 1.25" ID of the strut where the bearing goes is 1.625", which by my calculation is 1 and 5/8. I cannot find a bearing that is 1 1/4 X 1 5/8. Only 1 1/4 X 1 1/2 or 1 3/4 Cant find metric equivalent either. Brian Fry La Neige HdG MD 1993 37/40XL -- Joel 301 541 8551
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
