I was able to modify the new Schaefer end stops to fit the old track with a little carving. Might work for Kenyon. Rig Right sells the new stop. Very close. Jerry
Sent from my iPhone > On Jan 3, 2016, at 10:39 AM, John and Maryann Read via CnC-List > <cnc-list@cnc-list.com> wrote: > > Our baby stay is attached to the deck via Kenyon 1 1/4 inch traveler using > track model 1169. The track is an extrusion with 2 vertical and 2 horizontal > surfaces with hollow center. The jib sheets can get caught and chafed on > the forward edge so am looking for a cap to cover the end and provide a > smooth surface. Tried Rigrite who list the cap on their web site but they > advise they are no longer available. Defender has several on its web site, > but are for slipping over current track designs and will not fit > > Any thoughts? > > > John and Maryann > Legacy III > 1982 C&C 34 > Noank, CT > > > > This email has been checked for viruses by Avast antivirus software. > www.avast.com > > > _______________________________________________ > > Email address: > CnC-List@cnc-list.com > To change your list preferences, including unsubscribing -- go to the bottom > of page at: > http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com >
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
