This is my first post so please be kind if I am doing anything wrong. I have an '86 29 MKII purchased in august with leaking windows. There is obvious signs of repair to the gel coat around the windows so I am certain they have been replaced before. Windows are in good shape so I just need to re-bed.
How can I tell the difference between polycarbonate and acrylic? I have started to remove one of the windows by digging out the old sealant and carefully pulling it away and it bends a bit. Can I assume therefore it is polycarbonate? Any concerns about getting the window off later to reseal if using 3M VHB tape. 3M says this tape forms a 'permanent bond'. Derek McLeod on a C&C 29-2 used DOW 795. How did you hold the window in place while the 795 cured? Thanks. Bruce s/v 'Gyrfalcon' '86 C&C 29 MK II Kootenay Lake, BC
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
