So if the pickup was blocked, why on both occasions after bleeding(once in calm water and second time in rough water but after adding 5 more gallons to the tank) it ran without a problem for hours, 2nd time in the same rough seas.
The tank was out (dried out and inspected) over the winter in 2011/2012. So was the pickup and sender at which time I don’t remember seeing any signs of corrosion etc. It might be good to mention that prior to 2012, I had atomic 4 (gasoline) engine. I put westrerbeake in the spring of 2012 after a full rebuild. I kept the tank. Hoses were all new. My primary is the Racor 230R Diesel Spin-On Series filter/water separator. I change that and secondary filter every commissioning. No signs of water whatsoever. Also fuel that comes out while bleeding is clean. From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Paul Fountain via CnC-List Sent: Monday, July 06, 2015 9:18 AM To: cnc-list@cnc-list.com Cc: Paul Fountain Subject: Re: Stus-List westerbeake sucking in air on a half tank Or the pickup becomes blocked, and air gets sucked in elsewhere in the fuel system. Paul Fountain From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Frederick G Street via CnC-List Sent: Monday, July 6, 2015 9:12 AM To: cnc-list@cnc-list.com Cc: Frederick G Street Subject: Re: Stus-List westerbeake sucking in air on a half tank Petar — it might be that the fuel pickup tube is corroded, and either doesn’t drop as far down into the fuel as it should/used to, or you have some pits in it above the half-tank level that allow air it. Sounds like time to pull and check it. Fred Street -- Minneapolis S/V Oceanis (1979 C&C Landfall 38) -- Bayfield, WI On Jul 6, 2015, at 8:09 AM, Petar Horvatic via CnC-List <cnc-list@cnc-list.com> wrote: Anyone has an idea why this happened twice in a row. Two trips to Block island this year and at about the same spot, right where seas get a little lumpy, and on about half full tank, diesel sucks in air and dies. First time was pounding into 20-kts (not a good way to travel), second time with no wind but large confused seas. The first time I sailed and dropped a hook before bleeding the injectors. Second time I added 5 gal jerry can and after bleeding injectors in 6 foot swell got her started without a problem. Ran fine after that in same conditions. I guess I should check to make sure fuel gauge is calibrated, although I’ve been using it the past 3-4 years. Petar Horvatic Sundowner 76 C&C 38MkII Newport, RI
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
