No. Not sealer. Use the high temperature grey pipe dope On Jun 21, 2015 9:56 PM, "Sam Salter via CnC-List" <cnc-list@cnc-list.com> wrote:
> 2GM20F - I’m about to replace the mixing elbow - got the part. > There’s a pipe joint between the mixing elbow and the exhaust elbow that > screws into both parts. > Do I screw this piece in dry or (more likely) use some sort of sealant? > If I need sealant - what do you guys suggest? > I’ve got a tube of high temp silicone left over from installing my garage > heater, is this stuff OK? If not - what??? > > sam :-) > C&C 26 Liquorice > Ghost Lake Alberta > > > > _______________________________________________ > > Email address: > CnC-List@cnc-list.com > To change your list preferences, including unsubscribing -- go to the > bottom of page at: > http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com > > >
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
