New issue for me, but I hope others have run into this. Alera has a
pressurize potable water system. It uses grey colored hoses and
fittings throughout. All appear to be original except for those
around the three way valve I replaced a few years ago. One (or
possible more) of the "T" fittings where the hot and cold water runs
split behind the sink to go to the sink and shower in the head have
small leaks. Here's a picture
-https://www.flickr.com/photos/37365243@N00/17989742489/in/dateposted-public/
The leaks are not enough to be a huge problem in terms of volume.
But, they leak out from behind the bulkhead into the floor of the
head scandalizing the Admiral and making gett8ng them fixed a high
priority. Also, I suspect that I may have, or will have, similar
issues at other junctures that I have not discovered yet. According
to my brother, who has a CS40 at Niagara on the Lake with a similar
set up, this grey stuff was all the rage, including in residential
applications, until they learned that it started to deteriorate after
20 years or so, developing hair line cracks and leaks. The company
is now out of business, of course.
These are in a difficult location and appear to have been done
originally without any silicon tape sealant. I can probably get a
wrench on them but am worried that if I can to either tighten them or
loosen them to put on the tape sealant before tightening em back up
until they stop leaking, they'll break. Thus, turning a small
problem into a big one. Now to my actual question...
What do you think of using a sealant on these after a thorough
cleaning and drying process?
Has anyone done this successfully?
If so, what did you use?
If not, (this ought to be a good one) what sealant would you suggest
I try? (My Brother Tony suggested 3m 4200, but I'm not sure about that one)
As always, suggestions, stories and wise-assed remarks are all welcome!
thx
Tom B
Tom Buscaglia
SV Alera
1990 C&C 37+/40
Vashon Island WA
(206) 463-9200
www.sv-alera.com
_______________________________________________
Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go to the bottom of
page at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
