Related to the stanchion legs for gate thread Persistence currently does not have a gate and on the stern has double rail pushpit. Two changes I am considering is adding a gate on either side and a cutout in the top rail on pushpit . Adding a gate on the side would require a base, a stanchion and lifeline work. A cutout for stern ladder on pushpit would likely require top and bottom fittings to add a vertical support either side of ladder opening and a short section of detachable lifeline as a gate on the top rail.
Has anybody made these changes and what about a hint at the cost or better ways to do this? Currently swim ladder is a very long climb up the reverse transom and then over the double stern pushpit rails. The side is not so bad as is not a high freeboard but for elderly guests or four legged friends is a bit daunting in current setup. Mike Persistence 1987 Frers 33 Halifax
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
